Blown in Insulation

BLOWN IN INSULATION – Commercial & Residential

Are you looking for attic insulation for your Dallas, TX home? If the answer is yes, then you've come to the right place.
EHI specializes in the installation of attic insulation in residential, commercial, and industrial applications for both new construction and retrofitting of existing structures. Be it batt, spray foam insulation, or blown in insulation. Our installers are certified professionals with years of experience in the business. Based on an evaluation of your home or business our quality staff will determine which type of attic insulation services would reduce your energy costs.
To learn more, Give us a call at 972-552-0200 or fill out the form on our CONTACT US page for a prompt response..

HOW ATTIC INSULATION IN TEXAS WORKS

Insulation is measured in R-values. the higher the R-value, the better your walls and roof will resist the transfer of heat. The U.S. Department of Energy (DOE) recommends ranges of R-values based on local heating and cooling costs and climate conditions in different areas of the nation. The map and chart below show the DOE recommendations for your area. State and local codes in some parts of the country may require lower R-values than the DOE recommendations, which are based on cost effectiveness.

Although insulation can be made from a variety of materials, it usually comes in three types; each type has different characteristics.

Rolls and Batts or Blanket Insulation
are flexible products made from mineral fibers, such as fiberglass and rock wool. They are available in widths suited to standard spacings of wall studs and attic or floor joists: 2x4 walls can hold R-13 or R-15 batts; 2x6 walls can have R-19 or R-21 products.

Loose-fill Insulation
usually made of fiberglass, rock wool, or cellulose-comes in shreds, granules, or nodules. These small particles should be blown into spaces using special pneumatic equipment. The blown in insulation material conforms readily to building cavities and attics. Therefore, loose-fill insulation is well suited for places where it is difficult to install other types of insulation

Spray Foam Insulation
very effective in buildings with space limitations and where higher R-values are needed. Foam insulation R-values range from R-4 to R-6.5 per inch of thickness (2.54 cm), which is up to 2 times greater than most other insulating materials of the same thickness. Learn More

R-Value Map and Chart

Get a Quote

Your Name (required)

Phone

Zip Code

Your Email (required)

Service of Interest

Your Message

Product of Choice

EHI only uses the latest products and techniques to ensure superior energy performance.
For Attic Insulation the products of choice are:
Johns Manville and CertainTeed.
To learn more about the products we use, Click a logo below to visit the manufacturers' website.

CertainTeed Insulation
Johns Manville Insulation

Trusted Brands We Use

EHI only uses the latest products and techniques to ensure superior energy performance. We are a provider of foam insulation products by multiple manufacturers Including: BASF, Johns Manville, Quadrant and Bayer
BASF
Johns Manville
CertainTeed
Bayer
Quadrant
Greenguard